Siemens M20 Terminal Technical Description page 68

Siemens Information and Communication Products
AT+CLIR Calling line identification restriction
Test command Response
AT+CLIR=? +CLIR: (list of supported <n>s) OK
Parameter
see set command
Read command Response
AT+CLIR? +CLIR: <n>, <m> OK
If error is related to ME functionality:
+CME ERROR: <err>
Parameter
see set command
Set command Response
AT+CLIR=[<n>] TA restricts or enables the presentation of the CLI to the called party when originating a call.
The command overrides the CLIR subscription (default is restricted or allowed) when temporary
mode is provisioned as a default adjustment for all following outgoing calls. This adjustment can
be revoked by using the opposite command.
OK
Parameter
<n>
<m>
Reference Note
GSM 07.07 If other party sets CLIR then the M20 replies with +CLIP: number presentation restricted.
AT+CMEE Report mobile equipment error
Test command Response
AT+CMEE=? +CMEE: (list of supported <n>s) OK
Parameter
see set command
Read command Response
AT+CMEE? +CMEE: <n> OK
Parameter
see set command
Set command Response
AT+CMEE=<n> TA disables or enables the use of result code +CME ERROR: <err> as an indication of an error
relating to ME functionality.
OK
Parameter
<n>
Reference Note
GSM 07.07 The possible error result codes are listed in chapter
Version 8 dated 15.03.00
(parameter sets the adjustment for outgoing calls):
0 presentation indicator is used according to the subscription of the CLIR ser-
vice
1 CLIR invocation
2 CLIR suppression
(parameter shows the subscriber CLIR service status in the network):
0 CLIR not provisioned
1 CLIR provisioned in permanent mode
2 unknown (e.g. no network, etc.)
3 CLIR temporary mode presentation restricted
4 CLIR temporary mode presentation allowed
0 disable result code
1 enable result code and use numeric values
2 enable result code and use verbose values
AT command interface
.
5.9.2
A
68