Siemens M20 Terminal Technical Description page 42

Siemens Information and Communication Products
ATS10 Set disconnect delay after indicating the absence of data carrier
Read command Response
ATS10? <n> OK
Set command Response
AT10=<n> This parameter setting determines the amount of time that the TA remains connected in absence of
data carrier. If the data carrier is detected before disconnect, the TA remains connected.
OK
Parameter
<n>
Reference Note
V.25ter
ATS12 Set pause length for Hayes ESC sequence
Read command Response
ATS12? <n> OK
Set command Response
AT12=<n> This parameter setting determines the length of pause on the start and end of Hayes escape sequence
in. 0.1 sec.
OK
Parameter
<n>
Reference Note
V.25ter
ATV Set result code format mode
Set command Response
ATV[<value>] This parameter setting determines the contents of the header and trailer transmitted with result co-
des and information responses.
OK
OK
Parameter
<value>
Reference Note
V.25ter
Version 8 dated 15.03.00
1-15-255 number of tenths of seconds of delay
1-10-255 number of tenths of seconds of pause length
When <value> =0
When <value> =1
0 Information response: <text><CR><LF>
Short result code format: <numeric code><CR>
1 Information response: <CR><LF><text><CR><LF>
Long result code format: <CR><LF><verbose code><CR><LF>
AT command interface
A
42