Siemens M20 Terminal Technical Description page 161

Siemens Information and Communication Products
7) Enter the Pin number with the command AT+CPIN="xxxx", unless AT^SFLC (facility lock
for PIN code has been set. In this case the log-in to the GSM network will start automatically
after the ignition phase is completed
8) Once the M20T is logged into the net the LED is on. (usually about 5 sec or longer depending
on the network availability.)
8.2.4 Hyperterminal: Setup (M20.ht)
Using the Hyperterminal program: (Standard Windows application)
Copy the configuration file M20.ht (included on the CD-ROM) to the hyperterminal directory
(usually: c:\ ..... startmenu\programs\accessories\hyperterminal) up the M20T
To start:
START - programs - accessories - hyperterminal - "m20.ht"
Once the Hyperterminal window is opened and the keypresses are echoed, the M20 is ready for further commands.
To register the M20T into the net use:
Type: AT+CPIN="<four digit PIN code>"
8.2.5 Procomm Plus: Setup and activation
Getting started and basic scripts for voice and data calls and SMS (text mode).
8.2.5.1 Procomm Plus setup files:
(From the included CD-ROM copy the following files to the subdirectories of Procomm Plus on your PC)
Copy to directory:..... procomm Plus/
Connect_first.dir
Connect_first.ext
Copy to directory:.....procomm Plus/aspects
start.was
data_ic.was
data_og.was
sms_ic.was
sms_og.was
voice_ic.was
voice_og.was
Version 8 dated 15.03.00
configuration information
Data incoming
Data outgoing
SMS incoming
SMS outgoing
Voice incoming
Voice outgoing
Application notes
Blink
Lit
A
161