Siemens M20 Terminal Technical Description page 169

Siemens Information and Communication Products
1
8.2.8 Phone call
8.2.8.1 Mobile originated call
atd015265241;
_
CONNECT
NO CARRIER
ath
_
NO CARRIER
8.2.8.2 Redial a number
ATDL;
CONNECT
....
8.2.8.3 Incoming call
RING
ata
8.2.8.4 Call a number stored in a phonebook
atd>3;
CONNECT
....
atd>"SM",3;
CONNECT
....
8.2.9 Data transfer
atd015265241
_
connect 9600
.....
+++〈pause〉
ato
1. If not specifically mentioned, finish your commands with ENTER.
Version 8 dated 15.03.00
Dial the number you want to be connected with (always with dialling code)
You see the cursor while the called party's phone is ringing
Your call is answered
Your partner has hung up
To end the connection before your partner
If your call is not answered:
the cursor disappears after some time
The phone number last called is dialled again
Somebody calls you
"Pick up the receiver"
Rings up number 3 of your current phonebook
If you want to use a phonebook, different from the current one
Dial the number you want to be connected with (always with dialling co-
de)
NOTE: do not use a semicolon at the end of the command
You see the cursor while the other's phone is ringing
Your call is answered, the transfer rate is 9600 bit/s
You exchange data
Switches from transparent to command mode
Though the phone connection is still active, characters are no longer trans-
ferred to the other modem
Returns to transparent mode
Application notes
A
169