Siemens M20 Terminal Technical Description page 40

Siemens Information and Communication Products
ATS0 Set number of rings before automatically answering the call
Read command Response
ATS0? <n> OK
Set command Response
ATS0=<n>
This parameter setting determines the number of rings before automatic answering.
OK
Parameter
<n>
Reference Note
V.25ter
ATS2 Set Hayes ESC character
Read command Response
ATS2? <n> OK
Set command Response
ATS2=<n>
This parameter setting determines the characters used in Hayes ESC sequence.
OK
Parameter
<n>
Note:
Reference Note
V.25ter
ATS3 Set command line termination character
Read command Response
ATS3? <n> OK
Set command Response
This parameter setting determines the character recognized by TA to terminate an incoming com-
ATS3=<n>
mand line.
OK
Parameter
<n>
Note:
Note:
Reference Note
V.25ter
Version 8 dated 15.03.00
0 automatic answering is disabled
1-255 enable automatic answering on the ring number specified
1-43-127Hayes escape character
default 43 = +
0-13-127
default 13 = CR
Using other value than 13 may cause problems when entering commands
command line termination character
AT command interface
A
40