Kenwood NX-5000 Series Common Function Reference page 382

17 STRUCTURING A MULTI RF DECK/ MULTI CONTROL HEAD
17.2 Adding an RF Deck/ Control Head
6
Write the firmware.
To activate Multi RF Deck/ Multi Control Head, the firmware version 1.62.00 or later needs to be written.
The firmware version of a Control Head can be confirmed in Radio Mode Selection.
KFL
Figure 17-29 Triple RF Deck/ Dual Control Head (Firmware Setting)
Note
If "FPU MISMATCH" is displayed on the screen of the Control Head, proceed to step 7.
0
If "FPU MISMATCH" is not displayed on the screen of the Control Head, the procedure is completed with step 6.
0
7
Write the FPU data.
The FPU data for Triple RF Deck/ Dual Control Head is written in a Multi RF Deck system. Always write the FPU
data in a Multi RF Deck system. Refer to
configuration data.
KPG-D1
Note
If "FIRM MISMATCH" is displayed on the screen of the Control Head, start again from step 6.
0
If "FIRM MISMATCH" is not displayed on the screen of the Control Head, the procedure is completed with step 7.
0
Common FUNC (K, F)/Ver 2.20
Deck 1
RF
KRK-15B
Control Head
1
"Configuration in KPG-D1/ D1N if RF Decks Are
Deck 1
RF
KRK-15B
Control Head
Figure 17-30 Triple RF Deck/ Dual Control Head (FPU Setting 2)
RF Deck 2
KRK-15B
RF Deck 2
KRK-15B
1
Deck 3
RF
KRK-15B
Control Head
Switched" for writing
Deck 3
RF
KRK-15B
Control Head
CONTENTS INDEX
2
2
351