Using The Vibrator - Kenwood NX-5000 Series Common Function Reference

11 EXTERNAL PORTS
11.1 Universal Connector

Using the Vibrator

Vibrator is the function to vibrate the transceiver when the transceiver receives an individual call with Optional Signaling,
an NXDN Status Message or a Short Message. With this function, a user can recognize that the transceiver is receiving a
call even in noisy environments or an environment requiring silence.
The vibrator functions under the following conditions:
System
P25 Conventional If a Selective Call matches
0
P25 Trunking
0
0
0
0
NXDN Conventional
0
0
0
0
DMR Conventional
0
0
0
0
NXDN Trunking
0
0
0
Analog Conventional/
0
LTR Trunking
0
0
The vibrator vibrates for 500 ms and stops for 500 ms, and repeats this cycle 10 times.
However, in the following cases, even if the conditions for the vibrator to function are satisfied, the vibrator does not function.
During this state, the " " icon blinks.
When the transceiver receives another signal to match the Optional Signaling while the vibrator is activated after the
0
Optional Signaling matches
During the amount of time configured in Auto Reset Timer after pressing the PTT switch, if the transceiver is on a
0
channel where anything other than "None" is configured for Optional Signaling
When the transceiver receives the same call while the amount of time configured in Auto Reset Timer is counting
0
down
Pressing the Vibrator key toggles the Vibrator between enabled and disabled.
Vibrator can also be enabled or disabled by selecting "Vibrator" after entering Menu Mode by pressing the Menu key. (Refer
to Using Menu Mode.)
Common FUNC (K, F)/Ver 2.20
Table 11-2 Conditions for the Vibrator to Function
If the transceiver receives an Individual Call or Group Call
If the transceiver receives a Paging Call
If the transceiver receives a Telephone Call
If the Optional Signaling matches
If the transceiver receives a Status Message (other than status 226)
If the transceiver receives a Short Message
If the transceiver receives a Paging Call
If the transceiver receives an Individual Call or Group Call (except an Unaddressed Call)
If the transceiver receives a Status Message (except an Emergency Termination Status)
If the transceiver receives a Short Message
If the transceiver receives a Paging Call
If the transceiver receives an Individual Call or Group Call
If the transceiver receives a Status Message (other than status 226)
If the transceiver receives a Short Message
If the transceiver receives a Paging Call
If the Optional Signaling matches
If the transceiver receives a Status Message (except the status number 88, 90, 91, and 92)
If the transceiver receives a Short Message
If the transceiver receives a Paging Call
Conditions
CONTENTS
209
INDEX