How To Set And Add A Pmac615 Ac Meter - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual
Path
3.
----End

8.1.8.8 How to Set and Add a PMAC615 AC Meter?

Prerequisites
One end of the straight-through cable has been connected to the RS485 port on the PMAC615
AC meter, and the other end has been connected to the COM port on the ECC800.
Context
The model of the single-phase AC meter for the lighting control box is PMAC615.
Procedure
Step 1 Set the PMAC615 communications address.
1.
2.
Issue 05 (2019-09-16)
Parameter
Name
Device Address
Click Test Connect to check whether the ATS connects to the ECC800 properly.
− If the ATS connects to the ECC800 properly, click Confirm. The connected devices
are displayed in the Number of connected devices list.
− If the ATS does not connect to the ECC800 properly, check whether the cable
between the ATS and the ECC800 is connected properly, whether the ATS and
ECC800 are running properly, and whether the input parameters are consistent with
the ATS parameters.
After the PMAC615 is started, press
screen is displayed. Press
communications address setting screen.
Press and a blinking cursor is displayed. Press
address based on site requirements. Then press
Figure 8-16 PMAC615 communications address
Copyright © Huawei Technologies Co., Ltd.
Setting
In this example, Device Address is set to 1. During
actual configuration, set the device address for the
ATS based on the actual situation.
on the displayed screen and the configuration
until the ID prompt is displayed, indicating the
to confirm the address setting.
to modify the communications
8 FAQ
192