How To Set And Add An Ats - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual
3.
----End

8.1.8.7 How to Set and Add an ATS?

Prerequisites
One end of the straight-through cable has been connected to the COM port on the ATS, and
the other end has been connected to the COM port on the ECC800 collector, rack environment
unit, or ETH converter.
Context
The ATS (ABB) model is OMD800.
Procedure
Step 1 Set the ATS device address. On the ATS display panel, choose Device Configuration >
Modbus and set the device address.
Step 2 Add an ATS.
1.
2.
Table 8-8 Adding an ATS
Path
Choose System
Settings >
Device
Management
and click Add
Device. The
parameters for
adding devices
are displayed.
Issue 05 (2019-09-16)
Click Test Connect to check whether the PDU2000-M connects to the ECC800
properly.
− If the PDU2000 connects to the ECC800 properly, click Confirm. The connected
devices are displayed in the Number of connected devices list.
− If the PDU2000 does not connect to the ECC800 properly, check whether the cable
between the PDU2000 and the ECC800 is connected properly, whether the
PDU2000 and ECC800 are running properly, and whether the input parameters are
consistent with the PDU2000 parameters.
 The ATS device address is 1 by default.
 The initial password is 0001 for the ATS display panel.
Log in to the ECC800 WebUI as an administrator.
Add an ATS.
Parameter
Name
Device attribute
Device Type
Connect To
Communications
Port
Copyright © Huawei Technologies Co., Ltd.
Setting
Select ATS from the drop-down list box.
Select ATS from the drop-down list box.
Select ECC800 from the drop-down list box.
Select COM1 from the drop-down list box.
NOTE
The setting example indicates that the ATS is connected to
the COM1 port on the ECC800. If the ATS is connected to
another port, enter the number of the connected port.
8 FAQ
191