Huawei ECC800 User Manual page 161

ECC800 Data Center Controller
User Manual
WebUI Operations
Step 1 Log in to the ECC800 WebUI as an administrator.
Step 2 If the iCooling function needs to be used, choose Monitoring > Cooling > Running
Parameters. On the iCooling parameter setting page, set Enable iCooling to Yes and click
Submit to finish the iCooling function setting.
Figure 6-42 Setting the iCooling function
Step 3 Set the iCooling temperature set point and humidity setpoint according to the actual
environment.
Figure 6-43 Setting the temperature and humidity setpoints
Step 4 (Only for air cooled smart cooling product) Choose Monitoring > Cooling > Running
Parameters to access the Temperature and Humidity Parameters page. Check whether
Temperature and humidity control type is Cold-aisle.
----End
Issue 05 (2019-09-16)
− Rack environment units and cabinet-level temperature sensors are installed for IT
cabinets or network cabinets. The ECC800 can monitor the temperature of each
cabinet.
− At least one cold-aisle temperature and humidity sensor is installed for each smart
cooling product, and each smart cooling product can detect the sensor readings.
 When iCooling is enabled, smart cooling products enter the iCooling teamwork control mode.
 The temperature and humidity refer to the values at the air intake vents of the IT cabinets.
After iCooling linkage is enabled, if the preceding conditions are not met, the smart cooling product

automatically exits the iCooling teamwork mode and enters the standalone mode. To view Team
work status, choose Monitoring > Cooling > NetCol5000 > Running Info > Status Information.
 When iCooling is enabled, the T/H threshold can only be set on the ECC800 WebUI.
 When iCooling is disabled, smart cooling products enter the intelligent teamwork control mode
(teamwork control of smart cooling products).
Copyright © Huawei Technologies Co., Ltd.
6 Feature Description
151