Huawei ECC800 User Manual page 194

ECC800 Data Center Controller
User Manual
Table 8-2 Setting a device address
Device
Addre
ss
1
2
3
4
Step 2 Add a UPS2000-G.
1.
2.
Table 8-3 Adding a UPS2000-G
Path
Choose System
Settings >
Device
Management
and click Add
Device. The
parameters for
adding devices
are displayed.
3.
Issue 05 (2019-09-16)
Operate the DIP switch S2 on the optional Modbus card to set the UPS2000-G device address. Toggle
switches 1 to 8 of DIP switch S2 specify the device address in binary mode. ON indicates 0, and OFF
indicates 1.
Toggle Toggle
Switch Switch
1 2
OFF ON
ON OFF
OFF OFF
ON ON
Log in to the ECC800 WebUI as an administrator.
Add a UPS2000-G.
Parameter
Name
Device attribute
Device Type
Connect To
Communications
Port
Device Address
Click Test Connect to check whether the UPS2000-G connects to the ECC800 properly.
− If the UPS2000-G connects to the ECC800 properly, click Confirm. The connected
devices are displayed in the Number of connected devices list.
− If the UPS2000-G does not connect to the ECC800 properly, check whether the
cable between the UPS2000-G and the ECC800 is connected properly, whether the
UPS2000-G and ECC800 are running properly, and whether the input parameters
are consistent with the UPS2000-G parameters.
Copyright © Huawei Technologies Co., Ltd.
Toggle Toggle Toggle
Switch Switch Switch
3 4 5
ON ON ON
ON ON ON
ON ON ON
OFF ON ON
Setting
Select UPS from the drop-down list box.
Select UPS2000G-A from the drop-down list box.
Select ECC800 from the drop-down list box.
Select COM2 from the drop-down list box.
NOTE
The setting example indicates that the UPS2000-G is
connected to the COM2 port on the ECC800. If the
UPS2000-G is connected to another port, enter the
number of the connected port.
In this example, Device Address is set to 1. During
actual configuration, set the device address for the
UPS2000-G based on the actual situation.
Toggle Toggle Toggle
Switch Switch Switch
6 7 8
ON ON ON
ON ON ON
ON ON ON
ON ON ON
8 FAQ
184