Huawei ECC800 User Manual page 141

ECC800 Data Center Controller
User Manual
Step 6 Set running parameters for the AC actuator.
Table 6-20 Setting AC actuator parameters
Path
Monitoring > Aisle > AC Actuator
Group > AC Actuator > Running
Parameters
Step 7 Check the functions of the AC actuator.
Table 6-21 Function check
Check Method
Path: Monitoring > Aisle > AC Actuator Group > AC
Actuator
1. Choose Running Parameters, and set Set light
2. Choose Controls, select Light control, select ON,
When the light is normal, set Set light mode to Automatic. Path: Monitoring > Aisle >
AC Actuator Group > AC Actuator.
Step 8 Set camera parameters.
1.
2.
Issue 05 (2019-09-16)
mode is Manual.
and click Submit.
 If the camera is connected to the smart ETH gateway, you need to set camera parameters for
intelligent lighting linkage.
 The camera checks whether there are people motions in the aisle. If so, the AC actuator turns on the
lights.
If the IP address of the camera that is automatically connected is the same as the IP address of the

camera that is manually added, the information about the camera that is manually added is
overwritten.
Select the actual camera type and go to the camera web page. For details, see the section
about camera commissioning.
Choose Settings> Network > Platform Connection > Second Protocol Parameters.
On the ONVIF and GENETEC tab pages, set platform interconnection parameters.
Copyright © Huawei Technologies Co., Ltd.
Operation
Set Route 1 Control Mode to Light, and
click Submit.
Set Route 2 Control Mode to PAD
Charging, and click Submit.
NOTE
If two AC actuators are configured, you only
need to set the Route 2 Control Mode for one
AC actuator.
Normal Connection Status
The light is on.
6 Feature Description
131