GE UR Series Instruction Manual page 126

5.4 FLEXLOGIC™
Table 5–12: FLEXLOGIC™ GATE CHARACTERISTICS
GATES
NOT
OR
AND
NOR
NAND
XOR
Table 5–13: FLEXLOGIC™ OPERATORS
OPERATOR OPERATOR
TYPE SYNTAX
Editor INSERT
DELETE
End END
One Shot POSITIVE ONE
SHOT
NEGATIVE ONE
SHOT
DUAL ONE
SHOT
5
Logic Gate NOT
OR(2)
↓
OR(16)
AND(2)
↓
AND(16)
NOR(2)
↓
NOR(16)
NAND(2)
↓
NAND(16)
XOR(2)
LATCH (S,R)
Timer TIMER 1
↓
TIMER 32
Assign = Virt Op 1
↓
Virtual Output
= Virt Op 64
5-42
NUMBER OF INPUTS
1
2 to 16
2 to 16
2 to 16
2 to 16
2
DESCRIPTION
Insert a parameter in an equation list.
Delete a parameter from an equation list.
The first END encountered signifies the last entry in
the list of FlexLogic™ parameters that is
processed.
One shot that responds to a positive going edge.
One shot that responds to a negative going edge.
One shot that responds to both the positive and
negative going edges.
Logical Not
2 input OR gate
↓
16 input OR gate
2 input AND gate
↓
16 input AND gate
2 input NOR gate
↓
16 input NOR gate
2 input NAND gate
↓
16 input NAND gate
2 input Exclusive OR gate
Latch (Set, Reset) - reset-dominant
Timer as configured with FlexLogic™ Timer 1
settings.
↓
Timer as configured with FlexLogic™ Timer 32
settings.
Assigns previous FlexLogic™ parameter to Virtual
Output 1.
↓
Assigns previous FlexLogic™ parameter to Virtual
Output 64.
L90 Line Differential Relay
OUTPUT IS '1' (= ON) IF...
input is '0'
any input is '1'
all inputs are '1'
all inputs are '0'
any input is '0'
only one input is '1'
NOTES
A 'one shot' refers to a single input gate
that generates a pulse in response to an
edge on the input. The output from a 'one
shot' is True (positive) for only one pass
through the FlexLogic™ equation. There is
a maximum of 32 'one shots'.
Operates on the previous parameter.
Operates on the 2 previous parameters.
↓
Operates on the 16 previous parameters.
Operates on the 2 previous parameters.
↓
Operates on the 16 previous parameters.
Operates on the 2 previous parameters.
↓
Operates on the 16 previous parameters.
Operates on the 2 previous parameters.
↓
Operates on the 16 previous parameters.
Operates on the 2 previous parameters.
The parameter preceding LATCH(S,R) is
the Reset input. The parameter preceding
the Reset input is the Set input.
The timer is started by the preceding
parameter. The output of the timer is
TIMER #.
The virtual output is set by the preceding
parameter
5 SETTINGS
GE Power Management