Nur für den internen Gebrauch
3.3.4
HXGS3, HXGR3
Introduction
HXGS3 and HXGR3 are VoIP gateway boards (VoIP - Voice over IP) that provide the function-
ality of HG 1500 in HiPath 3550, HiPath 3350 (HXGS3), and HiPath 3500, HiPath 3300
(HXGR3):
Connection of a local LAN to the HiPath 3000 and connection with external LANs via the
●
ISDN and DSL interfaces of HiPath 3000.
Support for the conventional functions of an ISDN and DSL router with the additional func-
●
tionality of a media gateway for the transfer of voice, fax and data.
Forwarding of calls between IP-supported networks (LAN, intranet, Internet) and circuit-
●
switched networks (ISDN, PSTN).
Bidirectional video signal transmission on the SIP interface (OpenScape Personal Edition).
●
Configuration is performed via Web-Based Management (WBM) which enables the administra-
tion of HG 1500 without any special software requirements.
For information on how to calculate the number of boards required for HG 1500, see Section
2.5.
HXGS3/HXGR3 Installation
Up to three boards can be used in HiPath 3550 and HiPath 3500.
A maximum of one board is permitted in HiPath 3350 and HiPath 3300. Two boards can be in-
stalled only if PDM1 is not being used.
When using an HXGS3 in HiPath 3350, the power supply unit
UPSC-D.
It is not possible to operate an HXGS3 or HXGR3 and an
system.
For information on the configuration, refer to the HG 1500 Administration Manual.
A31003-H3590-S100-7-7620, 06/2012
HiPath 3000/5000 V9, Service documentation
Boards for HiPath 3000
Peripheral boards
PSUP
must be replaced with
LIM module
simultaneously in one
boards.fm
3-95