Upgrade Hipath 3000 For Signaling & Payload Encryption (Spe); Upgrading - Siemens HiPath 3000 Series Service Documentation

Table of Contents

Advertisement

Nur für den internen Gebrauch
9.2.3
Upgrade HiPath 3000 for Signaling & Payload encryption (SPE)
Overview
The Signaling & Payload encryption feature is provided in HiPath 3000/5000 V7 R4 or higher.
If a software version lower than V7 R4 is in use, it must be upgraded before the SPE feature
can be used in HiPath 3000. Please refer to the published release notes.
A hardware upgrade is not required. As a result of the increased demand by SPE for resources
further HG 1500 boards might be required.
9.2.3.1

Upgrading

If a software version lower than V7 R4 is in use, the following software upgrades must be per-
formed before the SPE feature can be used without restriction:
Upgrade of all HFA terminals to an SPE-enabled software version
Due to the introduction of EFC, HiPath 3000 V7 and higher is no longer upwardly compat-
ible with regard to the "Signaling & Payload Encryption" feature, except to HiPath 3000
V6.0 systems which have an EFC-enabled HG 1500 and EFC-enabled IP terminals.
Upgrade of all HG 1500 gateways to V9
Upgrade of the HiPath 3000/5000 to V9. The "VoIP Security" feature must be deactivated
before upgrading a HiPath 3000/5000 V9 to HiPath 3000/5000 V7. This is necessary due
to the fact that this feature is not compatible with the "Signaling & Payload Encryption
(SPE) feature described here.
Upgrade of administration program DLS and HiPath Manager E
Changes to configuration so that SIP-Q instead of CorNet-IP is used to network HiPath
3000 with HiPath 4000 V4.0 systems. The HiPath 4000 supports SPE only via the SIP-Q
protocol.
In HiPath 3000 V8 and HiPath 4000 V5 and later systems, only SIP-Q V2 pro-
>
tocol is supported for IP networking of these two systems. CorNet-IP protocol is
no longer supported.
Changes to the configuration of the option "Always use DSP", if HiPath 4000 networking
should still be achieved using H.323-Q (CorNet-IP). In this case, no SPE to the HiPath
4000 is possible either.
In HiPath 3000/5000 V7 and higher, the HiPath 4000 must be connected as an external
H.323 gatekeeper or external SIP registrar.
A31003-H3590-S100-7-7620, 06/2012
HiPath 3000/5000 V9, Service documentation
Expanding and Upgrading HiPath 3000
Upgrading HiPath 3000
exup.fm
9-35

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents