Upgrading Hipath 3000; Hardware Upgrade - Siemens HiPath 3000 Series Service Documentation

exup.fm
Expanding and Upgrading HiPath 3000

Upgrading HiPath 3000

9.2 Upgrading HiPath 3000
The following information describes the measures that are needed to upgrade the hardware
and software.
It is not possible to upgrade HiPath 3550 to HiPath 3500 or HiPath 3350 to HiPath
>
3300. This would require replacing the complete system.
9.2.1

Hardware Upgrade

The following hardware requirements apply to HiPath 3000/5000 V5.0 and higher.
Control boards
If the control board necessary for operating HiPath 3000/5000 V5.0 and higher is not available,
a replacement must be performed.
System Control board necessary for HiPath 3000/5000 V5.0 and higher
HiPath 3800 CBSAP
HiPath 3550 CBCC
HiPath 3350
HiPath 3500 CBRC
HiPath 3300
Note for upgrading from hardware < version 1.2:
>
If the following subboards are present, they must be replaced:
IMOD), MMC
For Deutsche Telekom AG only: The CBCP board S30810-Q2935-B201 must be replaced by
a CBCC board S30810-Q2935-A301.
Multimedia card MMC
For the operation of HiPath 3000/5000 V9, an
9-30
(S30810-Q2314-X and higher)
(S30810-Q2935-A401, S30810-Q2935-A301)
(S30810-Q2935-Z401, S30810-Q2935-Z301)
(replaces the FMC), CMA/CMS (replaces the CGM/CGMC).
MMC with minimum 128 MB is required.
A31003-H3590-S100-7-7620, 06/2012
HiPath 3000/5000 V9, Service documentation
Nur für den internen Gebrauch
IMODN (replaces the