Siemens SINUMERIK 840Di Function Manual page 333

Function abort
A function abort can be triggered by the following events:
• EMERGENCY STOP:
• The fixed stop monitoring function responds in the case of:
2.1.3 Block search response
Block search with calculation
The response is as follows:
• If the target block is located in a program section in which the axis must stop at a fixed
• If the target block is located in the program section in which the axis must not stop at a
• If the desired fixed stop status is reached, alarm message 10208 "press NC Start to
• At the start of the target block, FXST[x] and FXSW[x] are set to the same value as they
Block search without calculation
The commands FXS, FXST and FXSW are ignored.
FOC
FOCON/FOCOF is activated modally. It is already active in the approach block.
Travel to Fixed Stop (F1)
Function Manual, 08/2005 Edition, 6FC5397-0BP10-0BA0
– With an 840D control, the NC and drive are disconnected from the supply after
EMERGENCY STOP, i.e. the PLC must react.
– With an 840Di control, the NC and drive are disconnected from the supply after
EMERGENCY STOP, i.e. the PLC must react.
Caution
Make sure that after cancelling the function "travel to fixed stop" by
"EMERGENCY STOP" no dangerous machine situation
(MD37002 FIXED_STOP_CONTROL e.g. pulse blocking cancel) can arise.
– Exit from fixed stop position by axis
– Tool breakage
– Pulse disable
limit, then the fixed stop is approached if it has not yet been reached.
fixed limit, then the axis leaves the fixed stop if it is still positioned there.
continue the program" is output. The program can be continued after pressing NC Start to
acknowledge.
would have during normal program processing.
Detailed Description
2.1 General functionality
2-9