Configuring The Properties Of The Network Interfaces - Siemens SINUMERIK 840D sl Commissioning Manual

PLC commissioning
7.1 Creating a SIMATIC S7 project
7.1.4

Configuring the properties of the network interfaces

Introduction
In the STEP7 project, configure the following network interfaces you want to use to reach the
NCU 7X0:
● PROFIBUS DP, only with machine control panel for PROFIBUS (see PROFIBUS
● Ethernet
● integrated PROFIBUS
When creating a new project using the catalog, the configuration of the PROFIBUS interface
is called automatically.
Steps for PROFIBUS DP
1. You used the left mouse button to select NCU 720.1 and while holding down the mouse
button you dragged it to the "Station design" station window.
2. After you release the mouse button, configure the properties of PROFIBUS DP interface
for socket X126 (machine control panel) in the dialog box (see figure below).
Figure 7-4
3. This is an Ethernet machine control panel, which does not require configuration. Select
"Cancel".
4. Module NCU 720.1 with SINAMICS S120 is inserted into the HW config (see figure
below).
Note
With the <F4> key and confirmation of the question regarding "Reorganize", you can
reorganize the display in the station window.
44
machine control panel on the HMI (Page 259))
Properties of PROFIBUS DP
Commissioning Manual, 07/2007, 6FC5397-2AP10-3BA0
IBN CNC: NCK, PLC, drive