Tips
13.7 Extending/checking the topology
Figure 13-27 Power on reset (warm restart)
6. Press "OK" to perform an NCK power on restart (warm restart).
Figure 13-28 Component accepted
248
The unit configuration is finished. The component has been accepted.
You have the following options to assign this component (e.g. SMC20 with new encoder)
to a drive:
– Press "Drives" to open the drive wizard. Select the drive and run through the drive
wizard to the encoder configuration (Page 79).
– Press "OK" and assign this component later to a drive.
Commissioning Manual, 07/2007, 6FC5397-2AP10-3BA0
IBN CNC: NCK, PLC, drive