Panasonic LP-400 Series External Control Manual page 37

Terminal
Name/Description
No.
20 SELECT 0
21 SELECT 1
22 SELECT 2
With SELECT 0 to SELECT 2, the setting target of D0 to D15 are specified as shown in the table below.
While maintaining the input status of SELECT 0 to SELECT 2 and D0 to D15, turn on SET IN.
Count-down value correction
Data number for Rank/External offset
* The select input (SELECT 0 to SELECT 2) is not necessary to be switched to ON when specifying the
file number.
23 TIME HOLD: Time hold input
Performs marking of date and lot, reflecting the time when the input TIME HOLD (No. 23) is turned ON.
While this input is turned on, the laser marker retains the time and date of the internal clock at the point
when the input was turned ON, and the functional characters such as current date, expiry date, and lot are
marked with this time.
If the input TIME HOLD (No. 23) is turned ON when powering on the laser marker, it retains the system
startup time.
24 to 29 RESERVE: System reservation
Do not connect externally.
*1 : Signals of No. 1 and No. 37 are different depending on the controller type of NPN or PNP.
• NPN models: LP-4xx(T)U / LP-4xx(T)U-A / LP-4xxS9(T)U / LP-4xxS9(T)U-A / LP-VxxU / LP-VxxU-A / LP-W series
• PNP models (with "-C" in the end of the model name): LP-4xx(T)U-C / LP-4xxS9(T)U-C / LP-VxxU-C
Number input target
File No.
Count-up value correction
Counter No. to reset
SELECT 0
OFF
OFF
ON
OFF
ON
ME-LP400V-EX-6
SELECT 1 SELECT 2
OFF OFF
ON OFF
ON OFF
OFF ON
OFF OFF
37