HP Indigo Division Series Instruction For Use & Installation Instructions page 9

Heading Step Reference
16. Install the electrical
cabinet-to-cabinet
cables on page 61
17. Install the electrical
cabinet M1 cables to
PE1, PE2 on page 62
18. Install the electrical
cabinet M2 to PE1,
PE2 on page 62
19. Install the electrical
cabinet M1-to-master
console cables on
page 63
20. Install all Unidrive
cables on page 66
Electrical
wiring 21. Install the PE1-to-
PE2 cables on page
(180 mins)
67
22. Install the PROFIBUS
cables as on page 67
23. Install the CTNET
cables on page 68
24. Route the MPI
(MODBUS) cables on
page 69
25. Connect the ProfiBus
and CTNet cable
connections on page
69
Vacuum 26. Installing the vacuum
hoses hoses on page 70
(40 mins)
nd
2 Day
Floor platform 27. Install the floor
platform on page 72
Procedure
Install electrical cabinet M2 to cabinet M1
cabling.
Install electrical cabinet M1 to cabinet M2
cabling.
Install electrical cabinet M1 to PE1 and
PE2.
Install electrical cabinet M2 to PE1 and
PE2.
Install the electrical cabinet M1-to-master
console cables.
Leave the cables ends at the cabinet until
installation of the raised floor and master
console.
Install all PE1 and PE2 Unidrive cables in
electrical cabinets M1 and M2.
Install the PE1-to-PE2 cables.
Install ProfiBus communication cable
between electrical cabinets M1 and M2 and
PLC in cabinet M1.
Install CTNet cables between all Unidrives
at electrical cabinets M1 and M2.
Route the MPI (MODBUS) cable through
the ILP connection panel to the front of
PE1 and connect JTBD of the cable to
PTBD of the TBD.
Route the remaining connector JTBD to the
exit are of PE2 and connect it to PTBD of
the TBD.
Connect the following ProfiBus and CTNet
cable connections at electrical cabinets M1
and M2
Remove under-panel
Install and route all vacuum hoses from
electrical cabinets M1 and M2 to PE1, PE2
(short hoses 2-3 m), and ILP.
Wait for the raised floor and ILP to install
long hose (3-4 m).
Reinstall lower under-panel
Install floor platform according to
specifications in Site Preparation Guide.
Start at unwinder and ILP area. For press,
start at corners of press or wall.
CA294-03070 rev 00
Installation Manual
Notes and
check
Wait for floor and
ILP to connect.
page 9 of 153