Ilp Electrical Connections - HP Indigo Division Series Instruction For Use & Installation Instructions

3. Connect the interface cable (P/N GW Art. NR.8110.00361) to X4 in the unwinder
electronics compartment.
Connect the other end to JX66 in electrical cabinet M1.

ILP electrical connections

1. Install the following cables between the ILP connections panel and cabinet M1:
Cable
CA293-09160
Orange
CA293-09170
Green
CA293-09190
Green
CA293-09180
Orange
CA261-10240
CA261-10890
CA261-10590
CA261-11040
CA261-10880
CA261-09210
CA261-10900
2. Install the following cables between cabinet M1and the ILP connections panel :
Cable
CA261-10620
ProfiBus
CA261-10870
Green/yellow
3. Connect the following air hoses and cables to the ILP connections panel:
Cable
CA261-10710
Origination point ILP
FU Motor connection
FU Motor encoder
FB Motor encoder
FB Motor connection
ILP control cable X60 at
ILP JMB board
(ILP connection panel)
ILP/JX70 interlock cable
MPI bus to ILP TSP
(ILP connection panel)
ILP priming motor power at
JX22
ILP Ametek power at JX43
ILP Ametek control at JX2
ILP 24 VDC at JX57
Also, connection at JX59
Origination point
cabinet M1
ILP Profibus to I/O plate (ILP
connection panel) at 16I/O
Grounding cable
Grounding cable connection
at inner ILP
end point
ILP
Inlet hose to Water tank
Outlet hose to PE1
CA294-03070 rev 00
End point
cabinet M1
Connection JX26
FU UniDrive (Motor
encoder FU) at 26U0
U/W UniDrive (Motor
encoder FB) at 24U0
Connection JX24
Connection X60
Connection at JX70
MPI connection at PLC
53A1
Connection at JX22
Connection at JX43 and
DA-J2
Connection at JX2
Connection at JX57
End point
ILP
ILP platform at
connection at 53A1
Grounding cable
Grounding connection
at Grounding bracket in
cabinet M1
Origination point
Water pump at ILP
ILP compressor pump.
Installation Manual
Notes
Route the cable
from the ILP, under
the floor to the PE1
and PE2 exits
Cable labeled
1-46-05
Cable labeled
1-46-05
Notes
Notes
page 105 of 153