HP Indigo Division Series Instruction For Use & Installation Instructions page 32

r. Install the junction bars (P/N MJX-1852-01) between the two u-bases using two M6
Allen screws, spring washers and flat washers to secure each bar (Figure 15).
The distance between the u-bases is now fixed at 693.0 mm.
NOTE: Make sure to mount each PE to the correct u-base. PE1 has
a web feed door. PE2 has a web exit door.
The lifting jig should only be used if a forklift is either
unavailable or the site does not allow entry to a forklift.
CAUTION: Each section of the lifting jig has a diagram label
describing the position of the section when lifting
the press. Use each specific section in its correct
position as labeled.
Make sure to adhere to all the safety warnings
labeled on the lifting jig. The lifting jig should only
be used on horizontal surfaces and the maximum
lifting weight for the jig is 1800 Kg.
CA294-03070 rev 00
Installation Manual
page 32 of 153