2-2-8. LED-418 Board
Removing
1. Remove the side rear assembly and side front assem-
bly. (Refer to steps 1 to 3 in Section 1-3-1.)
2. Remove the camera cabinet upper assembly.
(Refer to steps 2 to 5 in Section 1-3-2.)
3. Disconnect the harness from the connector CN2101 on
the LED-418 board.
4. Remove the screw, and remove the LED-418 board.
BTP2 x 6
CN2101
Installation
5. Reinstall the LED-418 board in the reverse order from
steps 3 and 4.
6. Reassemble the unit in the reverse order from steps 1
and 2.
2-18
LED-418 board
2-2-9. SE-758 Board
Removing
1. Remove the side rear assembly and side front assem-
bly. (Refer to steps 1 to 3 in Section 1-3-1.)
2. Remove the gear press spring from the SE plate.
3. Disconnect the flexible flat cable from the connector
CN2151 on the SE-758 board.
SE plate
SE-758 board
CN2151
Flexible flat cable
Gear press spring
BRC-300/300P
BRU-300/300P