Sony BRC-300 Service Manual page 57

10. Remove the VC-343 board from the hook on the
camera assembly, and pull out the VC-343 board in the
direction of the arrow.
Disconnect the CN-2680 board from the connector
CN502 on the VC-343 board.
Camera assembly
Hook
CN-2680 board
CN502
BRC-300/300P
BRU-300/300P
VC-343 board
11. Remove the two screws, and remove the IF-944 board.
12. Disconnect the flexible flat cables from the connectors
(CN2001, CN2002) on the IF-944 board.
13. Disconnect the flexible flat cables from the connectors
(CN801, CN802) on the VC-343 board.
14. Remove the screw, and remove the VC-343 board.
VC-343 board
CN802
Flexible flat cables
Installation
15. Reinstall the IF-944 board and VC-343 board to the
camera assembly in the reverse order from steps 7 to
14.
m
. Attach the VC-343 board to the PC board spacer as
shown in the figure.
VC-343 board
PC board spacer
. Connect the CN-2680 board to the connector CN502
on the VC-343 board and the connector on the CD-
389 board (flexible card board) correctly.
16. Only when the VC-343 board is replaced, perform the
BRC-300/300P camera block electrical alignment.
(Refer to Section 3-2.)
17. Reassemble the unit in the reverse order from steps 1
to 6.
PC board spacer
IF-944 board
B2 x 3
CN801
CN2001
CN2002
B2 x 3
2-17