Worm Gear Assembly (Pan) - Sony BRC-300 Service Manual

2-1-7. Worm Gear Assembly (Pan)

Removing
1. Remove the base plate. (Refer to Section 1-3-4.)
2. Remove the SY-314 board.
(Refer to steps 2 to 4 in Section 2-2-11.)
3. Release one end of the gear press spring from the hook
of the base cabinet assembly.
4. Remove the screw, and remove the plate T4, holder
T3, two wave washers and holder T2 from the shaft of
the base cabinet assembly.
5. Pull out the pin from the shaft of the base cabinet
assembly, and remove the drive gear T.
Pin
Gear press spring
Hook
Drive geart T
Base cabinet assembly
BRC-300/300P
BRU-300/300P
Worm gear assembly (pan)
Holder T2
Wave washers
Holder T3
Plate T4
PSW2.6 x 6
6. Remove the two screws, and remove the worm base B
from the base cabinet assembly.
Base cabinet assembly
7. Remove the worm base B, gear press spring and two
holders W3 from the worm gear assembly (pan).
Holder W3
Worm gear assembly
(pan)
Gear press spring
Worm base B
PSW2.6 x 6
Worm base B
Holder W3
2-9