Installation
8. Reattach the worm base B, gear press spring and two
holders W3 to a new worm gear assembly (pan).
n
Reattach the worm gear assembly (pan) to the worm
base B with the holders W3 installed as shown in the
figure.
Holder W3
9. Reattach the worm gear assembly (pan) in the reverse
order from steps 3 to 6.
10. Reassemble the unit in the reverse order from steps 1
and 2.
2-10
Worm base B
2-1-8. Pan Motor
Removing
1. Remove the base plate. (Refer to Section 1-3-4.)
2. Remove the SY-314 board.
(Refer to steps 2 to 4 in Section 2-2-11.)
3. Remove the two screws, and remove the motor plate.
4. Remove the four screws, and remove the pan motor
from the motor plate.
PSW.SRW2.5 x 6
Installation
5. Reattach the pan motor in the reverse order from steps
3 and 4.
n
Pay attention not mix up the screws (PSW.SRW2.5 x
6) and the screws (PSW2.6 x 6).
6. Reassemble the unit in the reverse order from steps 1
and 2.
PSW.SRW2.5 x 6
Motor plate
PSW2.6 x 6
Pan motor
BRC-300/300P
BRU-300/300P