Executing Effects - Sony MVS-6520 User Manual

OFF: Executing the effect causes no change.
Step: There is no interpolation between
keyframes, so that the effect parameters are
updated each time a keyframe is passed.
Linear: Linear interpolation between
keyframes, resulting in constant speed
movement.
S-Curve: The rate of change accelerates and
decelerates before and after a keyframe, so
that the rate of change is maximum midway
between two keyframes.
Spline: The effect follows a smooth curved path
from each keyframe to the next.
The status area reflects the selected path type.
At this point, depending on the setting for Curve, the
effect for Hue and Xpt is also affected as shown in the
following table. In the menu, the Hue and Xpt settings
do not change, but the path type indication is dimmed
out.
Curve setting
OFF
Step
4
If you selected [Spline] as the path type, set the
following parameters.
No. Parameter
1 Tens
2 Bias
3 Cont
Changing the path type for Hue
1
In the Key Frame >Path >M/E-1 (6113.1), press the
[Hue] path type indicator for [Key1].
A path selection window appears.
2
Press the indication for the desired path type, to select
it.
CW: The hue changes in a clockwise direction
as seen on a Vectorscope.
CCW: The hue changes in a counterclockwise
direction as seen on a Vectorscope.
Short: The hue changes in whichever of the
clockwise and counterclockwise directions is
shorter.
Long: The hue changes in whichever of the
clockwise and counterclockwise directions is
longer.
260

Executing Effects

Hue change Xpt change
Does not change Hold
Changes as with Is not affected
the Step setting
Adjustment
Spline interpolation tension
Spline interpolation bias
Spline interpolation continuity
Changing the path type for Xpt
1
In the Key Frame >Path >M/E-1 (6113.1), press the
[Xpt] path type indicator for [Key1].
A path selection window appears.
2
Press the indication for the desired path type, to select
it.
Xpt Hold off: When replaying a keyframe,
change the inputs to the settings saved in
memory.
Xpt Hold on: When replaying a keyframe, do
not change the inputs.
Executing Effects
By means of the [RUN] button in the Flexi Pad, you can
play an effect as a continuously varying image. This is
referred to as effect execution
It is also possible to execute an effect from the device
control block.
Executing an Effect in the Flexi Pad
In the Flexi Pad, press the [EFF] button to switch to effect
operation mode.
The [REWIND] button and [RUN] button are displayed in
the memory recall section.
In addition, the alphanumeric display shows the number of
the last recalled register.
EFF button Alphanumeric display
Memory recall section
Region selection buttons
You use the [REWIND] button and [RUN] button in the
memory recall section to execute effects.
(1 p. 245)
.