Setting Dme Wipe Modifiers - Sony MVS-6520 User Manual

Adjusting DME wipe pattern parameters
Of the DME wipe patterns, the following have parameters
that can be adjusted.
When Brick (for two channels) is selected
(pattern numbers 2801 to 2804, 2811 to 2814)
No. Parameter
1 Side V Size X
2 Side V Size Y
3 Height
4 Center X
5 Center Y
a) The horizontal center position of the video pasted on Side V. At –100.00
the center is at the left edge of the screen, and at +100.00 the center is at
the right edge of the screen.
b) The vertical center position of the video pasted on Side V. At –100.00 the
center is at the bottom edge of the screen, and at +100.00 the center is at
the top edge of the screen.
When Frame in-out (for two channels) is selected
• Pattern numbers 2851 to 2854
No. Parameter
5 Delay
• Pattern numbers 2861 to 2864
No. Parameter
1 Rot X
2 Rot Y
3 Rot Z
5 Delay

Setting DME Wipe Modifiers

You can apply various modifiers to the DME wipe pattern:
setting the DME wipe direction, pattern position, etc.
For an overview of modifiers,
Variations and Modifiers" (p.
Specifying the DME wipe direction
(Direction)
You can specify the DME wipe direction (normal/reverse).
To specify the DME wipe direction in a menu
1
Open the M/E-1 >DME Wipe >Edge/Direction menu
(1164).
116
Basic DME Wipe Setting Operations
Adjustment
Horizontal magnification
Vertical magnification
Height of brick
a)
Horizontal center position
b)
Vertical center position
Adjustment
Timing for video selected on a
utility bus to appear on the screen
Adjustment
Rotation on the Y axis (horizontal
direction)
Rotation on the X axis (vertical
direction)
Rotation on the Z axis
Timing for video selected on a
utility bus to appear on the screen
1 "DME Wipe Pattern
114).
2
In the <Direction> group, specify the DME wipe
direction.
Normal: Regular direction
Normal/Reverse: Alternate between regular and
reverse for each transition
Reverse: Opposite direction of normal
To specify the DME wipe direction with a button
in the transition control block
In the transition control block of each switcher bank, press
the following direction selection buttons.
NORM: Normal
NORM/REV: Normal/reverse
REV: Reverse
Modifying the DME wipe pattern edge
(Edge)
1
Open the M/E-1 >DME Wipe >Edge/Direction menu
(1164).
2
If the selected pattern is in 2-channel mode, in the <Ch
Select> group, select the corresponding channel.
You can select more than one channel at the same
time.
3
Select the edge type in the <Edge> group.
Border: Border
Soft Border: Soft border
4
Set the parameters according to the selection in step 3.
When Border is selected
No. Parameter Adjustment
1 Width Border width
3 Luminance Luminance of border color
4 Saturation Saturation
5 Hue Hue
When Soft Border is selected
No. Parameter Adjustment
1 Width Border width
2 Inner Soft Border inner softness
3 Luminance Luminance of border color
4 Saturation Saturation
5 Hue Hue
Display indications when multiple channels are
selected at the same time
The indications for the parameters show the settings
on channel 1. When you adjust the settings, this
changes the settings on channel 2 by the same amount.