Configuring Safety Integrated Plus (F-Plc); Introduction - Siemens SINUMERIK 840D sl Configuration Manual

Safety configuration

9.8 Configuring Safety Integrated plus (F-PLC)

9.8 Configuring Safety Integrated plus (F-PLC)
9.8.1

Introduction

New safety functions are available in the SINUMERIK TIA Portal Toolbox with the Safety
Integrated plus (F-PLC) mode. The Safety Integrated plus (F-PLC) mode is supported as of
NCU V4.7.
The following safety functions are used in the SINUMERIK Integrated plus (F-PLC) mode:
● Use of PROFIsafe telegrams for SINAMICS Integrated or connected NX modules
● Programming of F-blocks with F-logic via the editors for F-FBD or F-LAD
● Handling of configurations and the F-library in the same way as with SIMATIC F-CPUs
● Configuration via the Safety Administration Editor (see below)
Safety Administration Editor
In the SINUMERIK Safety Integrated plus (F-PLC) mode, the "Safety Administration Editor"
is also available in the project tree.
It supports the following tasks:
● Display of the safety program status
● Display of the F-collective signature
● Display of the safety mode status
● Creation/organization of F-runtime groups
● Display of information on the F-blocks
● Definition/change of the access protection
● Definition/change of the general settings for the safety program
192
SINUMERIK STEP 7 Toolbox V14 SP1
Configuration Manual, 05/2017, A5E41846325