Configuring The F-Peripherals - Siemens SINUMERIK 840D sl Configuration Manual

Safety configuration
9.7 Configuring Safety Integrated (SPL)
9.7.2

Configuring the F-peripherals

During the configuring of F-peripherals with Safety Integrated (SPL), you can orient yourself
on the following handling overview with sample configuring sequence. This serves, however,
only as an introduction to the configuring and programming of SINUMERIK Safety Integrated
(SPL).
Therefore, observe the following documentation prior to configuring Safety Integrated (SPL):
● Function Manual, SINUMERIK Safety Integrated
Depending on the application area, the SINUMERIK NCU, being a part of plants and
systems, requires the observance of special standards and regulations. Observe the
appropriate safety and accident prevention regulations, e.g. IEC 60204-1 (general
requirements placed on the safety of machines).
This sample handling overview serves only as an introduction to the configuring and
programming of STEP 7 Safety Advanced with SINUMERIK. It cannot always be used for
effective regular operation. Before you do this, ensure that you reference the current
version of the SINUMERIK Safety Integrated Function Manual. The warnings and other
notes contained in that manual must be observed, even when they are not repeated in this
document!
The non-observance of these regulations can lead to severe injuries and damage to
machines and equipment.
Requirement
● The "SIMATIC STEP 7 Safety Advanced" option package has been installed.
(No license required: SIMATIC STEP 7 Safety Advanced without license corresponds to
the F-configuration tool from STEP 7 V5.x)
● The devices to be configured have been inserted
(at least one NCU and one peripheral device)
● The "Safety Integrated (SPL)" mode is activated in the NCU properties.
See: Changing the Safety Integrated mode
Note
Activating Safety Integrated mode at the start of the configuring work
If you activate the Safety Integrated mode first at the end of the configuring work, it is
possible that all parameters are no longer assigned automatically by the system and you
must match these values.
Consequently, activate the desired Safety Integrated mode directly after inserting the
NCU.
178
WARNING
SINUMERIK STEP 7 Toolbox V14 SP1
Configuration Manual, 05/2017, A5E41846325