Siemens HiPath 1100 Service Manual page 292

Configuring the system specifically for the client
Comments about the System's Programming Codes
Remote Administration via DTMF (157)
With this feature you can configure the HiPath 1100 remotely using a MF telephone.
Remote configuration:
●
Remote Configuration must be enabled and the programming extension must have a
conversation in progress on the external line over which programming is to be performed.
In Talk mode enter the code (*991) at the programming extension to transfer control of the
HiPath 1100 to the remote programmer. The remote programmer must then enter the
system password using a MF telephone.
To execute the required programming proceed as if the remote telephone was connected
directly to the system.
If there is a Fax/DID module available:
●
Enter the code (* 95) using the remote MF telephone after answering the call. The remote
programmer must then enter the system password using a MF telephone.
To execute the required programming proceed as if the remote telephone was connected
directly to the system.
If the system is connected through a serial cable to a PC with access to the tele-
phone system, the programming can also be done using a modem in conjunction
with the HiPath 1100 Manager. Refer to the instructions provided in the Help file.
Ending Remote Administration (196)
Ends remote configuration by means of a Standard MF telephone.
7.2.9 Entrance Telephone
Configuring an Entrance Telephone (115)
This function enables the system to use an entrance telephone. The HiPath 1100 allows for the
connection of up to four Entrance Telephones/Door Openers on extension slots. Each Entrance
Telephone must be individually activated in the system.
1. By default no slot is set as an Entrance Telephone.
2. Each module of the TFE interface allows only one entrance telephone to be con-
nected.
3. Each TFE module works as an entrance telephone OR pager interface. To use
both functions, two modules are required.
7-54
A31003-K1160-S100-03-7620
Service Manual