Optipoint Interface - Siemens HiPath 1100 Service Manual

6.2.1.4

optiPoint Interface

optiPoint 500 telephones that feature a USB Interface (Advance, Basic/Standard/Economy,
Entry) can be used as an USB interface for performing administrative tasks.
In this case there are two options for connecting via optiPoint: VCOM or CAPI.
a) Connections via optiPoint VCOM: This allows for simultaneous connection of up to 8
optiPoint telephones to the system, although speed is affected.
For this type of connection you can use either Administration USB drivers or
Administration+CAPI Interface USB drivers.
b) Connections via optiPoint CAPI: With this configuration the optiPoint connection is up
to 4 times faster when compared to a VCOM (Item A) optiPoint connection. However,
only one Administration connection at a time is allowed. Other Administration
configurations via CAPI optiPoint or ISDN remote connections to the system cannot
take place while there is a CAPI connection in progress.
For this type of connection you must use either Administration USB drivers or
Administration+CAPI Interface USB drivers.
Figure 6-5 Possible optiPoint Configurations
A31003-K1160-S100-03-7620
Service Manual
HiPath 1100 Applications
Manager Software
Billing
CommServer
CallBridge
for Data
Interf
UP0/E
HiPath
1100
Maximum number of interface
connections - 8
Programming the system using a PC
Possible USB
Configurations
Transmission
Status Monitor
optiPoint Telephones
Operation
6-10