Samsung DCS Programming Manual page 217

SAMSUNG
COMBINED SYSTEMS PROGRAMMING MANUAL
MMC: 603
FOR:
Purpose: Assigns trunks to a specific trunk group or to several trunk groups. This is very
useful for programming of LCR when more than one trunk is to be in several dialling
plans. There are two different modes of operation: (1) sequential and (2) distribute.
WARNING: One trunk can appear in more than one trunk group. If necessary, delete the
trunk member from other groups to prevent accidental access.
DCS
CI
CII
816
408/408i
iDCS100
iDCS500 'M'
iDCS500 'L'
OS500
ACTION
1. Open programming and select 603
Display shows (e.g. trunk group 9)
2. Enter valid trunk group (see above)(e.g. 81)
OR
Press VOLUME keys to make selection and press
RIGHT soft key to advance cursor
3. Press RIGHT soft key to change mode
OR
Press VOLUME keys to change mode to member
4. Press RIGHT soft key to move cursor to number of
member and enter valid member number (e.g. 04)
OR
Press VOLUME keys to make selection and press
RIGHT soft key to move cursor
5. Enter valid trunk number (e.g., 729)
OR
Press VOLUME keys to make selection and press
RIGHT soft key to return to step 2
6. Repeat steps 1–5 to remove trunk from group 9 (or
group 0) if necessary
ASSIGN TRUNK GROUP
ALL SYSTEMS
No. of Trunk Groups
11
11
11
4
2
11
11
50
30
MMC 603 (Page 1 of 2)
MMC PROGRAMS
No. of Group Members
01–80
01–10
01–40
01–10
1–4
01–40
01–99
01–99
01–99
DISPLAY
[9] TRK GROUP
MODE:SEQUENTIAL
[81] TRK GROUP
MODE:SEQUENTIAL
[81] TRK GROUP
MEMBER 01:NONE
[81] TRK GROUP
MEMBER 04:NONE
[81] TRK GROUP
MEMBER 01:729
FEBRUARY 2004