Samsung DCS Programming Manual page 163

SAMSUNG
COMBINED SYSTEMS PROGRAMMING MANUAL
MMC: 416
FOR: iDCS100 iDCS500
Purpose: Defines which ring destination table an E&M or DID trunk will follow for incom-
ing calls. There are three options for each trunk:
0 FOLLOW INCOM DGT
1 FOLLOW DID TRANS
2 FOLLOW TRK RING
ACTION
1. Open programming and select 416
Display shows
2. Enter desired trunk number (e.g., 705)
OR
Press VOLUME keys to make selection and press
RIGHT soft key to move cursor
OR
Select all trunks
3. Dial 0–2 to select option (e.g. 1)
OR
Press VOLUME keys to make selection and press
RIGHT soft key
4. Press Transfer/TRSF to store and exit
OR
Press SPEAKER to store and advance to next
MMC
Default Data:
Related Items:
ASSIGN E&M/DID RINGDOWN
OS500
When a trunk is set to this option calls will ring at the destination
that matches the digits received from the C.O. (Follows
406)
When a trunk is set to this option calls will ring at the destination
defined in
C.O.
Calls will ring at the destination defined in
trunk. If the destination defined in MMC 406 is a VMAA port or
group, the system will repeat the digits received from the C.O. to
the port when it answers.
If you select this option, press the right soft key and "NUM OF
DGT:" will appear in the display. Enter the number of incoming
digits from the C.O. (0–4).
(see section 1.5.2)
FOLLOW INCOM DGT
MMC 406 Trunk Ring Assignment
MMC 714 DDI Number and Name Translation
MMC 416 [iDCS/OS500] (Page 1 of 1)
For MMC 416 Assign AC15 Translation,
MMC 714 that matches the digits received from the
DISPLAY
[701] E&M TRANS
FOLLOW INCOM DGT
[705]
FOLLOW INCOM DGT
OR
[ALL]
FOLLOW INCOM DGT
[705]
FOLLOW DID TRANS
MMC PROGRAMS
FEBRUARY 2004
see above
MMC
MMC 406 for that
E&M TRANS
E&M TRANS
E&M TRANS