Program 10-2 Overview; Led 20: Padded Tone Return; Led 18: Two-Exchange Line Conference; Led 17: "Trns" Soft Key Immediate Transfer - Toshiba Strata DK40 Programming Manual

System & Station
Button/
LED X
MW cancel from VM: dial
04
#64 + [DN]
03 3 Ringing Modes
Hunt/C.F. override from
02
DSS console's phone
Tone First (from DSS
01
Console)

Program 10-2 Overview

You can make the following system assignments with Program 10-2:

LED 20: Padded Tone Return

With some local exchanges, callers may experience clicking or squealing sounds or a loud
DTMF tone return during or after dialling. To counteract this, it is recommended that padded
tone return or no tone return be enabled (LED 20 ON) or No DTMF tone return (LED 20
OFF and LED 11 ON). If this option is not selected (LED 20 OFF), Program 10-2, LED 11
selects normal level DTMF Return or No DTMF Return.
The optional padded DTMF frequency system tone is returned to callers at a lower-than-
normal volume level with each digit dialled from the telephone dial pad or when speed
dialling is used.
The tones are also heard by callers routed to voice mail when DK40 sends VM ID codes.

LED 18: Two-Exchange Line Conference

LED 18 should be OFF whenever Two-line (Tandem, Tie line External Call Forward, DISA)
connection is allowed (in Program 15-5 and Program 10-1, LEDs 19 and 20).
This increases the volume level between the two outside parties on a tandem (two-line)
connection, but it will not affect station volume if conferenced into the tandem connection. If
Two-Exchange line volume is low due to Exchange line loss, test the volume level with LED
18 ON. If it improves without adding hum noise, keep LED 18 ON.

LED 17: "TRNS" Soft Key Immediate Transfer

If this feature is activated and a transfer is initiated with the "TRNS" Soft Key, the call will
ring transfer (Camp-on Busy) immediately after the last digit of the called station (busy or
idle) number is dialled. This feature does not apply to transfers initiated with the fixed &QI2
7UQ button or "CONF" Soft Key.

LED 16: Executive Override Warning Tone

Executive Override allows a station user (if assigned in Program 30) to break into and listen
to an existing station conversation. A warning tone can be set optionally to be heard by the
conversing parties.

LED 15: External Page Included with All Call Page

If the All Call voice page access code (&6<) is entered, or if the paging number is dialled on
incoming tie lines, external page (all zones) may be included with All Call telephone speaker
paging. This option does not affect the $OO &DOO 3DJH button function, which activates
electronic and digital telephone speakers only, never external page
01).
3-20
LED ON
Program 10-2 System Assignments, Part 2 of 5
MW cancel from VM: Automatic When Answer
2 Ringing Modes
Hunt/C.F. override from DSS console
Voice First (from DSS Console)
Strata DK40 Programming Manual Spring 1999
LED OFF
(See Program 17, LED