Program 10-1 Overview; Led 20: Two-Exchange Line Conference; Led 19: Conference; Led 18: Ring Detect Time - Toshiba Strata DK40 Programming Manual

System & Station
Button/
LED X
Exchange Line DTMF
04 Signal Time 160
msec.
Dial Pulse Make Ratio
03
33%
Exchange Line Re-
02 seize time 1.5 sec. per
Program 42-0
Tone First (from SLTs,
01
DKTs and EKTs)

Program 10-1 Overview

You can make the following system assignments with Program 10-1:

LED 20: Two-Exchange Line Conference

Two lines can be conferenced with one or two telephones (digital, electronic, or standard).
Conference (see LED 19) in this program must be enabled for this feature to work. Also,
Two-line Conference must be allowed for Direct Inward System Access (DISA) and CF-EXT
calls across Tie lines external routing use of outgoing lines, and the transfer of Exchange
lines must be enabled for tandem connection with

LED 19: Conference

Gives stations the ability to enable (LED 19 ON) or disable (LED 19 OFF) any Conference.
System wide.

LED 18: Ring Detect Time

Sets normal ring detect time (LED 18 ON). Only use the normal setting, except unless
connected to Exchange lines that send ring signals less than 120 milliseconds.

LED 17: Station-to-Station Call Volume PAD

ON reduces station-to-station talk path volume (-8 dB). LED 17 should be OFF in all cases
except where extreme quiet room noise is expected.

LED 11: ABR Cycles/Redial Time

If activated from an electronic or digital telephone, Automatic Busy Redial will retry dialling
a telephone number on a line if a far end busy-signal is detected. Turn LED 11 ON to have the
system try up to 7 times every 120 seconds: turn OFF for up to 5 times every 60 seconds. This
feature is not available with standard telephones, is only available when using Digital
channels, and LCR speed up is not being used.
3-16
LED ON
80 msec.
LED 04 DTMF Signal Time applies to manual and speed dial
tones sent out of the system via Exchange lines. This applies
when dialling from any Toshiba telephone, including the 2000-
series Digital Telephone. LED 04 does not apply to Call
Forward or Voice Mail ID DTMF tones sent to voice mail ports.
(See Program
ports.)
40%
Exchange Line delay Re-seize guard time 0.45 secs.
Exchange line guard time is the time interval the system
requires to release an Exchange line and reseize it. If LED 02
is off, all lines are set with 0.45 second guard time; if LED is
on, guard time is 0.45 or 1.5 seconds per Program 42-0.
Voice First (from SLTs, DKTs and EKTs)
Program 10-1 System Assignments, Part 1 of 5
LED OFF
10-2, LED 06, for tones sent to Voice Mail
Program 15, Code
Strata DK40 Programming Manual Spring 1999
5.