Table of Contents
Advertisement
Praesideo 3.5 | Installation and User Instructions | 9 | System Configuration
43.6 Fiber interface
43.6.1 Procedure
Proceed as follows to configure a fiber interface:
1 Go to Configure > Equipment configuration > Fiber
interface. A screen similar to the one in figure 43.31
appears in the main frame of the web interface.
figure 43.31: Configure fiber interface step 1
2 Click the name of the fiber interface that must be
configured. A screen similar the one in figure 43.32
appears in the main frame of the web interface.
figure 43.32: Configure fiber interface, step 2
3 Configure the control inputs of the fiber interface
(see section 43.6.2).
4 Submit the changes. Note that the changes are not
permanent until the configuration is saved (see
section 40.4.4 and 40.4.5).
Bosch Security Systems | 2011-02
43.6.2 Control inputs
The configuration page for fiber interface control inputs
is similar to the configuration page for network
controller control inputs (see section 43.2.5).
43.7
CobraNet interface
Proceed as follows to configure a CobraNet interface:
1 Go to Configure > Equipment configuration > CobraNet
interface. A screen similar to the one in figure 43.33
appears in the main frame of the web interface.
figure 43.33: Configure CobraNet interface step 1
2 Click the name of the CobraNet interface that must
be configured. A screen similar to the one in
figure 43.34 appears in the main frame of the web
interface.
figure 43.34: Configure CobraNet interface step 2
3 Open the Audio inputs category to configure the
audio inputs of the CobraNet interface (see
section 43.7.1).
4 Open the Audio outputs category to configure the
audio outputs of the CobraNet interface (see
section 43.7.2).
5 Open the Control inputs category to configure the
control inputs of the CobraNet interface (see
section 43.7.3).
en | 361
Advertisement
Table of Contents
