Table of Contents
Advertisement
2011-02 | Installation and User Instructions | 5 | Call Stations
16.4 Installation
The keypad is suitable for table-top use. It can be
connected to a (remote) call station or to a keypad
which already has been connected to a (remote) call
station. Proceed as follows (see figure 16.5):
Caution
Disconnect the system cable from the (remote)
call station and back-up supplies before you are
going to connect a keypad to it. Connecting a
keypad to a powered (remote) call station can
damage the (remote) call station.
1 Remove the lid by sliding it to the left and snapping
it out of the keypad.
2 Connect the flat cable to the keypad connector and
assign the correct ID to the keypad. The short flat
cable is for keypad to keypad interconnection; the
long flat cable (that is supplied with the call station)
is for call station to keypad interconnection.
3 Slide the connecting plate into the bottom of the
keypad.
4 Fasten the connection plate using three screws.
5 Put the lid back by sliding it to the right and
snapping it into the keypad.
figure 16.5: Installation
Bosch Security Systems | 2011-02
1
4
2
5
3
en | 210
Advertisement
Table of Contents
