Display Meanings And Remedies - Sanyo VSP-8000 Instruction Manual

DISPLAY MEANINGS AND REMEDIES

Menu screen display
Display
ADDRESS ERROR
DBL. ADR.
Error (during entry)
No OPE.
(during operation)
Error
(during connection)
FAIL
FIND
LOCKED
LOCKED BY MASTER
No ADR.
NO ALARM
NO CHANGE
unregistered
WAITING
Note: If "No ADR" appears during operation despite communication having been established with the controller and device
(timelapse VCR, etc.), there may be a conflict within the system between data from the controller and data from the device.
In this case repeating either command will return the communication back to normal.
Meaning
Address between 5 and 7 was set.
The same address as another controller
was set.
Two devices have the same address.
Entry exceeds existing limits.
The device does not support the specified
operation.
Though device is in standby, requested
operation was tried three times and could
not be executed.
Requested alarm No., day/hour, or
day/hour/minute recording could not be
found.
Requested alarm No., day/hour, or
day/hour/minute recording was found.
Security lock of unit is activated.
Security lock of master controller is
activated.
Address does not exist (e.g., has not been
set).
Alarm list has no alarm entries.
Status list has no status entries.
Device is not registered in a group.
Bus carrying data to devices is busy and
device will not operate.
A potential difference has occurred in the
computer connected to the VSP-8000 and
RS-485 signals are not operating properly.
Set another address between 0 and 4.
Set the address of one of the devices to a
different address.
Reenter value within limits.
Read the instruction manual of the device.
Wait a moment and try again.
Enter the secret code and deactivate
security lock.
Deactivate lock at master controller.
Recheck and enter correct address.
Check alarm list after ALARM lamp flashes.
Check status list after STATUS lamp
flashes.
Either specify that device or register it in a
group.
Device is treated as if in standby and
requested operation will be tried three
times. Wait a moment and try again.
Please ensure that the earth terminal of
this equipment, or the earth terminal of the
computer, is connected to earth.
45
Remedy Page
6
13
10
10
38
43
44
40
42