Table of Contents
Advertisement
MULTIPLEXER OPERATION
Switching monitors for operational control
1
Press the CAM/MPX button to return to multiplexer control mode.
2
Press the MON2/SPOT button.
•
The monitor number entry screen will appear.
3
Enter the monitor number with the numeric keypad and press
ENTER button. (Example: 2)
Note: The camera to be controlled is being switched automatically to the
camera whose number has been set in the selected spot monitor.
4
Press the CAM/MPX button to switch to camera control mode.
Switching the camera to be controlled
1
Press the FULL button while the system is in camera control mode.
•
The camera number entry screen will appear.
2
Enter the camera number with the numeric keypad and press
ENTER button. (Example: 5)
[A] If a camera not manufactured by Sanyo is selected
"OTHER" will appear in the display if the selected camera is not manufactured
by Sanyo. Pressing command buttons of the CAMERA keypad will not change
display of this message.
M X : 0 0 1 C < O T H E R >
S P O T 1
C H : 0 5
[B] If camera control is not possible
"UN CON" will appear in the display if camera control is not possible due to
automatic switching of the selected monitor or an active alarm condition. Please
refer to "Switching the camera to be controlled".
M X : 0 0 1 C
U N C O N
S P O T 1
[C] If camera control permission is refused
If the selected camera is not connected to the multiplexer, "OFF CON" will
appear indicating that camera control is prohibited. Please refer to "Switching
the camera to be controlled".
M X : 0 0 1 O F F C O N
S P O T 1
24
CAM
M X : 0 0 1
S P O T 1 : 0 5
MPX
MON2
SPOT
M X : 0 0 1
< S P O T :
1
2
3
M X : 0 0 1
S P O T 2 : 0 2
4
5
6
7
8
9
0
ENTER
CAM
M X : 0 0 1 C
MPX
S P O T 2
C H : 0 2
FULL
M X : 0 0 1 C < C H -
1
2
3
M X : 0 0 1 C
4
5
6
S P O T 2
C H : 0 5
7
8
9
0
ENTER
>
-
>
-
- Quick Links:
- Connecting the Vsp-8000
Hide quick links:
Advertisement
Table of Contents
