Setting The Security Locks - Sanyo VSP-8000 Instruction Manual

SETTING THE SECURITY LOCKS

To prevent unwarranted use of the VSP-8000 while it is operating, the unit or the entire system can be set to a security lock by
entering a secret code. There are two types of security locks: a simple lock that does not depend on the time, and a timer lock that
only activates during a set time period. Also, by locking the master controller (address 0), the entire system becomes locked.
Simple locks
1
Press the MENU button.
Then press the + (or – ) button until " SECURITY LOCK" is displayed
and press the ENTER button.
•
The secret code entry screen appears.
2
Enter the secret code (e.g., 1234) with the numeric keypad.
Note: The secret code will be required to deactivate the lock, so be sure to
write it down so it is not forgotten.
For mistakes: Press the CLEAR button and reenter the secret code.
If the secret code is lost or forgotten, contact your nearest Sanyo dealer or
representative.
3
Press the ENTER button.
•
"NO USE" (to use the simple lock function) appears flashing.
4
Press the ENTER button again.
•
The simple lock is set and the initial screen appears.
Note: If a button on the operation panel is pressed when the simple lock has
been applied, the system will wait for a secret code to be entered and
button operations will be ineffective until the secret code is entered.
Also, the lock will be released when the secret code is entered. To return
to the initial screen without releasing the lock, please press the CLEAR
button or the MENU button.
Deactivating the lock
1
Press any button on the operation panel.
•
The secret code entry screen appears.
2
Enter the secret code with the numeric keypad.
•
The lock is deactivated.
Note: To reset the security lock or timer lock, return to the "SECURITY LOCK"
screen and reenter the secret code.
Using the security lock for the entire system
If the security lock is activated at the master controller (address 0), then the whole
system becomes locked. If the whole system is locked, then "LOCKED BY
MASTER" will be displayed in the menu screen of all the controllers except the
controller with address 0.
Note:
•
Do not set two or more controllers to address 0. If there is more than one controller with address 0, the controller that was first
set will become the master controller.
•
If the entire system is locked by a controller set to address 0, then all connected devices will be locked because operation from
the controller will not be possible. Please use separate locking if only individually devices need to be locked.
MENU
10
- +
C O D E = ? ? ?
ENTER
1 2 3
C O D E = 1 2 3
4 5 6
7 8 9
0
ENTER C O D E = 1 2 3 4
T I M E R : N O U S E
ENTER S A N Y O C o n t r o l l e r
2 1 : 2 0 : 0 0
C O D E = ? ? ?
L O C K E D
1 2 3
C O D E = 1 2 3
4 5 6
L O C K E D
7 8 9
0
L O C K E D
B Y M A S T E R
?
4
?
4