Sanyo VSP-8000 Instruction Manual page 34

CAMERA OPERATION
Call-up command operation list
The in the table tells you the corresponding section below for reference.
Call-up command
L-L PHASE
PRESET MEMORY
ALARM OUT
RESET
ZOOM PRESET
Note: Because the type of device connected is automatically detected by the system, devices that do not have compatibility with a
certain command will prevent that command from appearing in the menu screen.
Operations
A: L-L PHASE
Adjusts the vertical synchronization
1.
Press the + (or – ) button to select
"L-L PHASE".
2.
Press the ENTER button.
C M : 0 0 1 L - L . P
U P : + D O W N : -
3.
Press and hold the + (or – ) button to
adjust the vertical synchronization.
C M : 0 0 1 L - L . P : u p
C M : 0 0 1 L - L . P : d w
4.
Press the CLEAR button.
Adjusts the vertical synchronization
Records the filming position, zoom and focus into the memory address
specified by the position number
Selects whether an alarm will be output from the camera
Resets current settings
Sets maximum Tele/Wide zoom limits
+: Maximum Tele, – : Maximum Wide
B: PRESET MEMORY
Records the filming position, zoom and
focus for a position number
1.
Press the + (or – ) button to select
"PRESET MEMORY".
2.
Press the ENTER button.
C M : 0 0 1
P R E S E T M E M O R Y
3.
Use the joystick lever to adjust the
desired filming position.
4.
Press the ZOOM W or ZOOM T button
to set the desired zoom ratio.
5.
While pressing the 0 button, press the +
(or – ) button to adjust the focus.
6.
Specify the position number with the
numeric keypad.
Example: 25 → [2][5]
C M : 0 0 1
P R E S E T P O S I T I O N
7.
Press the ENTER button.
C M : 0 0 1
P R E S E T P O S I T I O N
8.
Repeat steps 3 to 7 to set the filming
position, zoom and focus for the next
position number.
9.
Press the CLEAR button.
Operation
N o . - -
-
N o . - 2 5
N o . - 2 5
33
Menu screen
( A) CM:001
L-L PHASE
CM:001
( B) PRESET MEMORY
CM:001 AL.OUT
ON:+ OFF:-
CM:001 RESET?
YES:+ NO:-
CM:001 ZOOM
ON:+ OFF:-