Setting The Communication Speed - Sanyo VSP-8000 Instruction Manual

SETTING THE COMMUNICATION SPEED

Set the communication speed (baud rate) at which data is transferred. The baud rate set here should match the baud rate set for
devices that this unit will operate.
1
Press the MENU button.
Then press the + (or – ) button until " BAUD RATE SET" is displayed
and press the ENTER button.
•
The baud rate setting screen appears.
2
Press the + (or – ) button to select the desired communication speed
(baud rate).
•
The display will change from "19200" → "2400" → "4800" → "9600" → "19200"
(units: bps) each time pressed.
3
Press the ENTER button.
•
Set the baud rate to return to the "BAUD RATE SET" screen.
Press the MENU button to return to the initial screen.
Note: Communications will be interrupted if the baud rate changes after communications have been established with connected
devices. In this case, return the settings to the original values.
MENU
12
- +
B A U D R A T E S E T
1 9 2 0 0 b p s
ENTER
(Flashing)
- +
ENTER