System Menu Option 15, Time And Date - GE AL-1103 User Manual

Entering a user pin code
The display shows the user's PIN code if the user number is 1000 or less. This feature must be programmed by
the installer to authorize access.
Note: You cannot program a PIN code that already exists, one that will conflict with another user's duress code (refer to
Section 4, Duress Signal), or one that conflicts with another user's door code (See
page 59).
To enter a user pin code, do the following:
1. Press ENTER Figure 1). The keypad
displays the enter a user pin code window
(Figure 71).
2. Enter the PIN code for the user and press
ENTER.
Note: A user, who is allowed to both open doors
and arm/disarm the system, should have a
PIN code of at least five digits. See
menu option 22, Open doors
3. Enter the PIN code again (Figure 72) to
confirm and press ENTER.
Note: Update your "User" list when changes are
made.

System menu option 15, Time and date

Use this menu to program a new time and date. The time and date are visible during normal use of the Alliance
system and all internal functions rely on them.
A new date or time only needs to be programmed when the Alliance system is first installed, or if the time
needs to be adjusted for daylight saving time.
PIN Code: 1234
Press ENTER:
.
Figure 71. Enter user pin code
PIN Code:
Code:
System
on page 59.
Figure 72. Confirm user pin code
Confirm PIN Code
Code:
Alliance system menu
System menu option 22, Open doors
Chapter 2 51
on