NEC Express5800 series User Manual page 119

NOTE: If the "Windows Server 2003 CD-ROM" or the back-up
CD-ROM remains to be inserted in the CD-ROM drive, it does not
affect the process.
6.
If the external CD-ROM drive (N8460-001) is connected to the hard disk drive where the
CPU Blade starts, press F6 key while the message "Setup is inspecting your computer's
hardware configuration..." is displayed at the top of the screen.
IMPORTANT: There is no visible indication on the screen when
<F6> key has been pressed.
If you do not need to press the F6 key, the following procedure is not necessary. Perform
the upgraded installation according to the on-screen messages. For more information,
refer to the "First Step Guide".
7.
If the following message appears, press S.
Setup could not determine the type of one or more mass storage
devices installed in your system, or you have chosen to
manually specify an adapter. Currently, Setup will load
support for the following mass storage devices.
The following message appears.
manufacturer-supplied hardware support disk
8.
Insert the N8460-001 Driver FD into the floppy disk drive and press Enter.
A list of drivers for the USB CD-ROM drive is displayed.
9.
Select "USB driver" and press Enter.
Then, it returns to the screen of step 7.
IMPORTANT: Conduct key entries when the access lamp on the USB
floppy disk drive is off (or access to the floppy disk does not occur).
10.
If HostRAID is installed, press S again.
Please insert the disk labeled
into Drive A:
* Press ENTER when ready.
Installing the Operating System 5-9