Table of Contents
Advertisement
Chapter 2 Installation
Network configuration
Confirmation of the network menu
When installing this product to the projection monitor, the network on-screen menu
items for this product are activated automatically. If not activated, the product may
not have been installed correctly. Please check item "Mounting" (☞ p.16).
Configure the network
Before performing the network configuration, prepare network address numbers (IP
Address, Subnet Mask, Default Gateway, DNS) assigned to the projection monitor.
Ask your network administrator for the network address.
For example, the case where the following network address is set up is explained.
IP Address
Subnet Mask
Default Gateway
DNS
The default network configuration is set as follows.
IP Address
Subnet Mask
Default Gateway
DNS
1
Set up network setting "On"
Turn on the projection monitor and display the menu on the screen. Select network
menu and then select "Network setting" sub menu. Set network setting mode
"On". When the mode is set "On", the Network Unit starts booting and displays
message "Please wait..." on the screen until the booting is complete. After that the
menu display will disappear on the screen.
Network menu
✐ The network unit begins restarting each time the mode is set "On".
18
: 192.168.1.201
: 255.255.255.0
: 192.168.1.1
: 0.0.0.0
: 192.168.0.2
: 255.255.255.0
: 0.0.0.0
: 0.0.0.0
e t
P J - N
e r
a n i z
O r g
LI N
K
A C T
Select "On" or "Off"
with 7,8 button
Advertisement
Table of Contents
