Table of Contents
Advertisement
Chapter 4 Controlling the Projection Monitor
Change the mode of the registered projection monitor
To change the mode of the registered projection monitor, select a mode with the pull-
down menu button under the IP address of the target projection monitor and then
click Set button.
Status
If some of the registered projection monitors are
disabled by some reasons (such as disconnecting the
power source, disconnecting the LAN cable, discon-
necting from the network), control changes will con-
tinue to be effective for the projection monitors that
are still active. At the same time, the deactivated
projection monitors are excluded from the multi-con-
trol. The status of the registered projection monitors
are indicated under the projection monitor name.
See the table below for status indications.
Status
Description
(blank)................The projection monitor is connected to the network correctly
Unconnected .........The projection monitor may not be connectedd to the network. Please check the con-
nection and network configuration of this projection monitor.
PIN code error .......The PIN code is incorrect. The PIN code for the multi-controlled projection monitors
must be the same. Change the PIN code of this projection monitor to the common
PIN code.
* The Network Unit updates the status at the time when the multi-control function was executed.
✐ If the multi-controlled projection monitor is in the standby mode, any change is not effective
except timer setting.
✐ It is recommended that a specified projection monitor should be chosen for setting as a mas-
ter when you use this multi-control function. The control for the multi-controlled projection
monitors will become too complicated operation if this function is used for each projection
monitor.
✐ If the registered projection monitor is not connected to the network, it will take some time to
complete the multi-control operation because of waiting for the response from each registered
projection monitor.
56
Mode
Operation
Control ................. Multi-controlling the projection monitor
OFF..................... Excluding from the multi-control
Delete .................. Deleting from the multi-control
* This function is not available with the Light mode.
Status
Advertisement
Table of Contents
