Q&A - Sanyo PJ-Net Organizer POA-PN30 Owner's Manual

Q&A
Installation/Access
Q
Why doesn't the setting page appear in my web browser?
A
Following causes are possible. Please check them.
1. The projection monitor does not connect to the network.
Check LED indicators status (☞ p.15).
- Check the connection of LAN cable if the LINK indicator does not light
orange.
- Check the network configuration of the projection monitor if ACT indica-
tor does not light green.
2. Function "Network" in the projection monitor is not set to "ON".
Set up by using the projection monitor's on-screen menu (☞ p.18).
3. Wrong network configuration of the projection monitor
Check the network configuration of the projection monitor by using
the projection monitor's on-screen menu (☞ p.18).
4. Wrong network configuration of the computer.
Check the network configuration of the computer.
5. The Network Unit is used with the default setting (☞ p.18).
6. The proxy setting of the web browser is not set correctly (☞ p.70).
7 . The computer does not provide TCP/IP protocol.
Q
No setting page in my web browser? Is the problem in the network
or in the projection monitor? I would like to find out the problem
whether it is in the network or in the projection monitor
A
Check it by the following steps
1. Disconnect the projection monitor from the network and connect the pro-
jection monitor and computer with the UTP cross cable directly.
2. Change network configuration of the computer and projection monitor as
shown in the example below.
(Projection monitor setting)
IP Address
Subnet Mask
Default gateway
DNS
(Computer setting)
: 192.168.0.2 IP Address
: 255.255.255.0 Subnet Mask
: 0.0.0.0 Default gateway
: 0.0.0.0 DNS
Q&A
: 192.168.0.5
: 255.255.255.0
: (blank)
: (blank)
PJ-NET ORGANIZER
OWNER'S MANUAL
77