Fujitsu Eternus DX60 S2 User Manual page 68

Chapter 4 Connecting Cables
4.2 Host Interface Connection
The following explains how to connect the miniSAS cable.
IMPORTANT
Procedure
1
FUJITSU Storage ETERNUS DX60 S2 Disk storage system User's Guide -Installation-
• To help with miniSAS cable management and prevent incorrect
connections, attach labels to the miniSAS cables and make a note of
connection origins and destinations.
• When connecting miniSAS cables, check the connector orientation and
then firmly push it all the way in.
When disconnecting miniSAS cables, use the pull-tab to extract the
connector.
This section describes dual controller type as an example.
Note that there is only controller 0 (CM#0) for single controller type.
Connect the miniSAS cable to the ETERNUS DX Disk storage system.
Insert the miniSAS cable connectors in the controller 0 (CM#0) and controller 1 (CM#1)
SAS ports.
Do not connect this cable to the DI (OUT) port.
IMPORTANT
Copyright 2014 FUJITSU LIMITED
68
P3AM-5502-05ENZ0